KISS 4U V3 SKX – Preliminary Rev. 0.6
www.kontron.com
// 39
7/
Assembly
To assembly and maintain the KISS 4U V3 SKX, no special tools are required.
7.1.
Opening and Closing the Cover
To access, internal components open the cover.
Energy hazards-240 VA present inside the chassis!
Before removing the KISS 4U V3 SKX’s cover, ensure that the system is switched off and
disconnected from the mains power supply.
Activities such as work inside the system, system expansion with expansion cards, or
maintenance must be performed by qualified personnel aware of the associated dangers!
To open the cover, proceed as follows:
1.
Switch off and disconnect the system from the mains power supply.
2.
If the front access panel is locked, open the securing mechanism using the supplied key.
3.
Loosen the cover’s knurled screw on the front side (Figure 25) and the two knurled screws on the rear side
(Figure 26) that secure the cover.
Figure 25: Loosening Front Side Knurled Screw
Figure 26: Loosening Rear Side Knurled Screws
4.
Pull the cover out slightly as shown in Figure 27 to release the cover’s front centering and fixing brackets (Figure
22, pos.3 and pos. 4) from the retaining brackets of the chassis.
