KISS 4U V3 SKX – Preliminary Rev. 0.6
www.kontron.com
// 49
Figure 35: Assembling Slide Rails in an Industrial Rack Cabinet
1
Short front bracket
2
Long rear bracket
3
Telescopic slide rail attached to
Industrial rack cabinet
Short brackets are usually used at the front of the chassis and long brackets at the rear.
8.7.
Installing as a Tower
To installing the KISS 4U V3 SKX platform as a tower variant:
1.
Remove the handle brackets from the front left side and right side, as described in Chapter 8.2 :Removing the
Handle Brackets.
2.
Add the four rubber feet to the left side of system as described in Chapter 8.1: Attaching the Rubber Feet.
Attach the four rubber feet close to the four corners of the underside of the tower to
improve the tower’s stability.
3.
If required, remove the front access panel and two front access panel side-plates, as described in Chapter 8.3:
Removing the Front Access Panel and Front Access Panel Side-Plates.
4.
Stand the system upright with the fan assemble in the lower part and the drive bays in the upper part of the
front side.
When operating the KISS 4U V3 SKX as a tower, the fan assembly including the three system
fans must be located in the lower part and the drives in the upper part of the front side.
2
1
3
