RMVS-1U RMVS KVM Switch User’s Guide
Hot Plugging
The RMVS KVM’s supports
hot plugging
- components can
be removed and added back into the installation by unplugging their
cables from the ports without the need to shut the unit down. In order
for hot plugging to work properly, however, the procedures described
below must be followed:
Switching Station Positions:
You can switch station positions by simply unplugging from the old
parent and plugging into a new one. After you do, in order for the OSD
menus to correspond to the change, you must reset the Station IDs in the
OSD. See
RESET STATION IDS
, p. 4-11, for details.
Hot Plugging CPU Ports:
In order for the OSD menus to correspond to a CPU port change, you
must manually reconfigure the OSD to reflect the new port information.
See SCAN/SKIP MODE under the
F3 SET
function (p. 4-6), and the
two
Set Port
selections under the
F4 ADM
function (p. 4-8), for details.
Note:
If the computer’s Operating System does not support hot
plugging, this function may not work properly.
2-5
