3.5"-SBC-APL V2.0 - User Guide, Rev. 2.2
www.kontron.com
// 42
Signal
Description
V) on hardware reset when the transmitter is empty or when loop mode operation is initiated.
RXD
Received Data, receives data from the communications link.
DTR
Data Terminal Ready, indicates to the modem etc. that the on-board UART is ready to establish
communication link.
DSR
Data Set Ready, indicates that the modem etc. is ready to establish a communications link.
RTS
Request To Send, indicates to the modem etc. that the on-board UART is ready to exchange data.
CTS
Clear To Send, indicates that the modem or data set is ready to exchange data.
DCD
Data Carrier Detect, indicates that the modem or data set has detected the data carrier.
RI
Ring Indicator, indicates that the modem has received a ringing signal from the telephone line.
TX+/-
Transmitted Data differential pair sends data to the communications link.
RX+/-
Received Data differential pair receives data from the communications link.
GND
Power Supply GND signal
7.10.
LVDS Panel Connector (LVDS1)
The 18/24-bit, 1/2-channel LVDS connector is based on 30-pole connector type JAE JS-1267-30(G1)NH.
Figure 23: LVDS Connector LVDS1
Table 36: Pin Assignment LVDS1
Pin
Signal
Note
1
LVDS_A0-
2
3
LVDS_A1-
4
5
LVDS_A2-
6
7
GND