SmartClient-KLU - User Guide, Rev. 1.2
// 19
4.2.
Rear I/O Panel
Figure 1: Rear I/O Panel
1
2-pin Phoenix DC-In Power Connector (see Chapter 4.2.1)
2
Power Switch (see Chapter 4.2.2)
3
HDMI 2.0 (see Chapter 4.2.3)
4 DP (see Chapter 4.2.4)
5
Line-In (see Chapter 4.2.5)
6
Line-Out (see Chapter 4.2.6)
7
Mic-In (see Chapter 4.2.7)
8 GbE (see Chapter 4.2.8)
9
USB 3.0 (see Chapter 4.2.9)
10 RS232/422/485 (see Chapter 4.2.10)
4.2.1.
2-pin Phoenix DC-In Power Connector
The power adapter converts AC power to DC for use with this 2-pin Phoenix connector. Power supplied through this
connector supplies power to the PC. To prevent damage to the PC, always use a power adapter with correct output
voltage.
4.2.2.
Power Switch
Press this switch to turn the system on or off.
Even when the system is turned off via the power switch there is still a standby voltage on
the baseboard. The unit is only completely disconnected from the DC mains, when the power
is removed.
4.2.3.
HDMI 2.0
The SmartClient-KLU provides one HDMI 2.0 connector. One external (digital) display can be connected to this HDMI
2.0 connector.
9
10
1
2
3
4
5
6
7
8
8
9
9
9
10
