SmartClient-KLU - User Guide, Rev. 1.2
// 26
1
Mounting Clamp with Screw
2
Mounting Opening with Cover (Remove the cover before hooking the mounting clamp into it.)
8.
The system must be attached firmly by tightening the screws. Always tighten screws on the opposite side of the
front panel.
6.1.2.
System Mounting by Use of a VESA Mounting Kit
The SmartClient-KLU comes with VESA FDMI 100 standard mounting holes (Figure 7).
Figure 7: VESA mounting hole locations
Depending on the ordered SmartClient-KLU configuration, your system may be supplied with a VESA mounting kit
(Figure 8). The kit consists of two parts: a base bracket (Figure 8, pos. 1) to be fixed permanently on the mounting
surface and another hooked bracket to hold the SmartClient-KLU with a hand-screw knob (Figure 8, pos. 2) to secure
two brackets.
Figure 8: Optional VESA mounting kit
