![background image](http://html.mh-extra.com/html/konvision/kum-4k-series/kum-4k-series_user-manual_1996699023.webp)
23
23
1.
When the parameters of the monitors are
misadjusted, enter the factory reset option and
restore to factory setting.
2.
When the monitor's screen display or sound is not
normal, you can enter the factory reset option to
return to the factory settings in case of non-
hardware failure.
Use this feature, you can reset this monitor to factory
settings.
The factory settings can be restored when the following
conditions occur on the monitor:
Use this feature, you can reset this monitor to factory
settings.
The factory settings can be restored when the following
conditions occur on the monitor:
To do factory reset, please follow the below six steps:
1.
Press MENU/EXIT button to enter main menu.
2.
Turn VOLUME knob to item Setup and select it.
3.
Press KNOB Key to select the menu settings sub-menu
option.
4.
Press the DOWN button to select the factory setting option.
5.
Press the KNOB Key to select whether to restore
the factory settings. Select "Yes" and the monitor
will be restored to factory settings.
Note:
1.
Please hold the plug tight when you pull out the
power cord.
2.
Please do not connect the power supply before you
insert the cable well.
3.
Please use power cord match to monitors.
1. The left side is S1/S2/S3 Key bar.
2. The right side shows the Config corresponding
to the currently selected key. The settings in
Config can be preset in the menu item “Scene
Settings”
3. When one of the buttons S1/S2/S3 is pressed
to switch the channel, the channel will be
switched to the input source corresponding to
the Config button.
1. Press the S-MODE button to review the
Config1~Config8.
2. Use the IMAGEADJ(U/D) knob to select other
configurations in the S-MODE button interface,
and then press the S1, S2 or S3 button of the
current channel to switch to other configurations.
3. Press the Knob to quickly switch to Scene
Config menu item and modify the Config.
S1/S2/S3 Button Switching
Configuration
S-MODE Button Switching
Configuration
S-MODE Button Switching
Configuration
AC Power Connection