Calibration option of the temperature sensor.
Display of actual temperature by request.
Digital temperature sensor.
Settings are stored in memory for power failures.
delay of 1 minute
the fan will start, followed by the
compressor within the next minute.
The unit will cycle ON/OFF based on the temperature reading. Fan speeds are automatically set by the controller to achieve optimum
performance.
Minimum ON and OFF cycle times are imposed by software, to prevent "short cycling".
alternating with the temperature reading.
- Unplug and re plug the unit after 10 minutes.
57
56
70
57
57
57
57
58
57
56
57
14
57
57
57
F0
F0 F1
F0 -1
Actual temperature:
PRESS
SET temperature:
PRESS
PRESS and RELEASE
To increase:
PRESS once per degree
To decrease:
PRESS once per degree
The new value will be memorized and the controller will reset automatically.
The new value will be memorized and the controller will reset automatically.
Wait 5 seconds
USE for each degree of positive offset
for each degree of negative offset
BEFORE AFTER
TEMPERATURE
(range is 5
3
-64
TO CHANGE FROM
CONTROLLER
OPERATION
ACTION
A negative offset will result in a warmer cabinet and a positive offset will result in a cooler cabinet.
The new value will be memorized and the controller will reset automatically.
(wait one minute)
KEYS
+
-
Summary of Contents for WineKoolR 250
Page 1: ...250 500 WineKoolR TM ...
Page 11: ...7 INSTALL CENTER POSTS 2 4 3 TO P S LO TS ...
Page 24: ...250 500 WineKoolR TM ...
