Kool Tek G8 Hot and Cold Water Cooler Manual
7
Problem
Possible Cause
Suggested Solution
Water
dispenser is
leaking
Drain cap and silicone
seal are not secure.
Ensure seal is secure in drain plug and
tighten cap.
Water is not
hot or cold
enough
The unit is unplugged.
The circuit breaker is
tripped or a fuse is blown.
Temperature limit
tripped.
Thermostat needs to be
adjusted colder.
Plug into the outlet.
Reset the breaker or replace the fuse.
Allow the temperature of the hot
water tank to cool for approximately
15-30 minutes. The tem¬perature limit
thermostat will reset automatically
once sufficiently cooled and the
cooling system will reactivate
automatically.
Adjust thermostat between high (cool)
and low (colder) levels to achieve
desired temperature.
Water
dispenser is
not dispensing
water
Mineral deposits clogging
tanks.
Possible air pocket.
Slow or no water flow
into cooler (when using
direct water hook-up)
Possible ice build-up due
to thermostat set too
high.
See Cleaning the Reservoirs.
Push down on the dispenser buttons
to prime the unit
Inspect water tubing for kinks
Unplug overnight, then reset. Adjust
thermostat to high, slowly increasing
based on desired use and need for
cold water
Water
dispenser is
noisy
Water dispenser is
uneven.
Make sure the dispenser is on an even
surface that can support its weight
TROUBLESHOOTING