6
For most computer cases, the PSU-1300ATX-12N must be installed from inside
the chassis due to its width. If you do not have a Koolance case, please skip to the
next section.
Koolance PC3-726, PC3-736, PC4-1026, and PC4-1036 systems must give up one
hard drive cage in order to fi t the PSU-1300ATX-12N. Begin by removing the screws
for this rear drive cage, the top screws for the front hard drive cage, and the PSU
partition wall. Screws are located above and below the hard drive area.
Remove the PSU partition wall and
rear hard drive bay.
With the top screws of the front
hard drive cage removed, it
should be possible to remove
the rear drive cage by carefully
fl exing the top partition (without
completely removing the front
cage).
