Dimension and position
Angle
Deference
Min H of chimney
β
A (m)
H (m)
< 1.85
0.5 m
15
o
> 1.85
1 m
< 1.50
0.5 m
30
o
> 1.50
1 m
< 1.30
0.5 m
45
o
> 1.30
1 m
< 1.20
0.5 m
60
o
> 1.20
1 m
YES NO
O
PERATIONAL PROBLEMS DUE TO DEFECTS OF THE SYSTEM CAPACITY
Besides all influencing atmosphere agents, the wind is the most important agent for the system operation.
6.8 CONNECTION TO THE ELECTRICAL POWER SUPPLY
The stove must to be installed by qualified personnel in compliance with EN 10683.
All required cables and connectors are put into the pellet stove. The installation is quick and simple.
Before each assembling of the system, an automatic test of the system is performed for its proper operation.
Depend of some configuration some cables and connectors can be changed. When you turn on the product
for the first time, you should do the following: When you are sure that the assembly is properly done, it is
possible to start initial turning
ON
the pellet stove the setting might be made either through the control
panel or the software.
For normal operation of the stove ALL PARAMETERS IS SAVE ON THE MOTHERBOARD.
The product should be connected to the electrical power supply. Our pellet stoves are supplied with a
medium temperature persistent cable. In case you need to replace the cable, call an authorized service
gent. Before you connect to the electrical power supply, you should check the following:
a
‐
whether the characteristics of the electrical power supply meet the requirements indicated on the plate
‐
whether the connection is properly grounded
‐
The cable should not have temperature higher than 75
o
C.
In case of a direct connection to the electrical power supply, call an authorized person, an electrician. If you
do not use the pellet stove for a longer time period, you should disconnect it from the electrical power
supply. The connection should be easily accessible.
7.0 USAGE
7.1 SAFETY PRECAUTIONS
BEAR
IT
Page 10
Taking into consideration that the pellet stove develops high temperature, the young and adult persons
should be careful, and especially the children. It is forbidden to pour water or any other liquid which might
cause temperature shock. Do not place flammable objects near the pellet stove.
