14
The inner and outer flaps are connected by a piece of wire and pushrod plastic tubes.
Pierce a piece of pushrod tube near to the trailing edges of the flaps to be connected (parallel to the
trailing edge) so that they can be connected by a piece of bend wire.
Glue
the tubes from the outside
carefully.
Bend a piece of ø 1 mm wire so that the angle is similar to that of the glued-in tubes. Insert the wire
into the tubes only, do not glue it.
Attach a variable linkage connector to the servo lever and connect to the right-angled levers with 2
wires with Z-bends. Alternatively, only one wire, in V-shape and with Z-bends at the ends, may be
used.