2
Parts needed for the finishing of the model:
Carbon Strip (stringer) 3x0,5 mm
2 pc
Pushrod connectors (linkage stoppers)
4 pc
Adhesives:
Cyanoacrylate (CA) glue (super glue) thin +
medium
Activator (Kicker) for Cyanoacrylate glue
Polyurethane (PU) glue (e.g. Ponal PUR
glue in bottle or UHU PU MAX in bottle or
Purex Rapid)
Technical information:
Wingspan:
850 mm
Overall Length:
610 mm
Flying weight:
~380 g
RC Functions:
Rudder, elevator, ailerons, motor, (optional flaps)
Recommended equipment:
Brushless motor:
Emax CF 2812 or Turnigy D2822/14 - 1450kv
1 pc
Electronic Speed Controller (ESC):
Brushless 12-15 A
1 pc
Propeller:
GWS 8x4 + prop adaptor
1 pc
Servos:
Micro 5-6 gram
4 pc (+1 optional for flaps)
Battery:
3S Li-Pol 800 - 1000 mAh
Receiver:
4-6 channels
Parts included in the set:
Fuselage parts
2 pc
Center section of the wing
1 pc
Outer Wing parts (left hand + right hand)
2 pc
Engine cowling
1 pc
Engine shutter
– 3D printed part
1 pc
Tail group (empennage)
2 pc
Main Landing gear wire (
ø 2 mm)
1 pc
Main Landing gear wheels
2 pc
Tail Landing gear wheel
1 pc
Steel wire for pushrods
(ø 1 mm)
1 pc
Pushrod tube (Plastic, inner
ø 1 mm)
1 pc
Foil for windshield
1 pc
Sticker for the windshield
1 pc
Rear windows
2 pc
Plastic tubes for landing gear
6 pc
Aluminum tubes for landing gear
2 pc
Set of Fiberglass parts (motor bulkhead, control horns, hinge levers etc.)
Tools needed to assemble the model:
A sharp knife or scalpel, pins, drywall sanding mesh, steel ruler, soldering iron, paint (water based,
synthetic or color spray cans:
Montana
, DupliColor,
PrismaColor…) and common model building
tools.
All parts are glued with super glue (CA), unless stated otherwise.
Before starting the assembly, read carefully the Assembly Instructions!