5
Left side part of the fu vertical stabilizer:
Place the left-side fuselage part (with the
inside facing down) and the vertical stabilizer
on a flat surface.
Pierce the ø 1 mm steel
wire, at an angle as in the figure, to the
inside of the fuselage and further back into
the cockpit. Slide the pushrod tube onto the
wire and pull it through the fuselage. The
rest of the tube is to cut into the left side part
of the fuselage in the same way as in the
right side. Cut in the rudder servo, in the
same way as the elevator servo, in the right-side part of the fuselage.
Prepare a Z-Bend on the wire again and insert it in the longer control horn, which will later be glued to
the rudder from below (the tail landing gear wire needs to be glued between the rudder and the control
horn).
