32
4.3 Port
Configuration
Port Configuration group enables you to enable/disable port state, or configure port
auto-negotiation, speed, duplex, flow control, rate limit control and port aggregation
settings. It also allows you to view port status and aggregation information.
Following commands are included in this group:
4.3.1 Port Control
4.3.2 Port Status
4.3.3 Rate Control
4.3.4 Port Trunking
4.3.1 Port
Control
Port Control commands allow you to enable/disable port state, or configure the port
auto-negotiation, speed, duplex and flow control.
Select the port you want to configure and make changes to the port.
In
State
column, you can enable or disable the state of this port. Once you disable, the
port stop to link to the other end and stop to forward any traffic. The default setting is
Enable which means all the port are workable when you receive the device.
In
Speed/Duplex
column, you can configure port speed and duplex mode of this port.
Below are the selections you can choose:
Fast Ethernet Port 1~7 (fa1~fa6) : AutoNegotiation, 10M Full Duplex(10 Full), 10M Half
Duplex(10 Half), 100M Full Duplex(100 Full) and 100M Half Duplex(100 Half).
Gigabit Ethernet Port 7~9: (gi7~gi9) : AutoNegotiation, 10M Full Duplex(10 Full), 10M Half
