33
Duplex(10 Half), 100M Full Duplex(100 Full), 100M Half Duplex(100 Half), 1000M Full
Duplex(1000 Full), 1000M Half Duplex(1000 Half).
The default mode is Auto Negotiation mode.
In
Flow Control
column, “Enable” means that you need to activate the flow control
function of the remote network device in order to let the flow control of that corresponding
port on the switch to work. “Disable” means that you don’t need to activate the flow control
function of the remote network device, as the flow control of that corresponding port on the
switch will work anyway.
Once you finish configuring the settings, click on
Apply
to save the configuration.
Technical Tips: If both ends are not at the same speed, they can’t link with each other. If
both ends are not in the same duplex mode, they will be connected by Half mode.
4.3.2 Port
Status
Port Status shows you current port status.
The description of the columns is as below:
Port: Port interface number.
Type: 100Base-TX -> Fast Ethernet port. 1000Base-TX -> Gigabit Ethernet port.
Link: Link status. Up -> Link UP. Down -> Link Down.
State: Enable -> State is enabled. Disable -> The port is disable/shutdown.
Speed/Duplex: Current working status of the port.
Flow Control: The state of the flow control.
SFP Vendor: Vendor name of the SFP transceiver you plugged.
Wavelength: The wave length of the SFP transceiver you plugged.
Distance: The distance of the SFP transceiver you plugged.
