18
4 Feature Configuration
This chapter explains how to configure JetNet 5728G software features. There are four
ways to access the switch: Serial console, Telnet, Web browser and SNMP.
JetNet 5728G series Industrial Managed Switch provides both in-band and out-band
configuration methods. You can configure the switch via RS-232 console cable if you don’t
attach your admin PC to your network, or if you lose the network connection to your JetNet
5728G. This is so-called out-band management. It wouldn’t be affected by the network
performance.
The in-band management means you can remotely manage the switch via the network.
You can choose Telnet or Web-based management. You just need to know the device’s IP
address. Then you can remotely connect to its embedded HTML web pages or Telnet
console.
Korenix web management page is developed by JAVA. It allows you to use a standard
web-browser such as Microsoft Internet Explorer, or Mozila, to configure and interrogate
the switch from anywhere on the network.
Note: IE 5.0 or later versions do not allow Java applets to open sockets by default. Users
have to directly modify the browser settings to selectively enable Java applets to use
network ports.
Following topics are covered in this chapter:
4.1 Command Line Interface (CLI) Introduction
4.2 Basic Setting
4.3 Port Configuration
4.4 Power over Ethernet
4.5 Network Redundancy
4.6 VLAN
4.7 Traffic Prioritization
4.8 Multicast Filtering
4.9 SNMP
4.10 Security
4.11 Warning
4.12 Monitor and Diag
4.13 Device Front Panel
4.14 Save
4.15 Logout
