36
Click on Folder icon to select the target firmware file you want to upgrade.
Figure 4.2.8.3 Firmware Upgrade – TFTP Server mode.
Type the IP address of TFTP Server and Firmware File Name. Then click on Upgrade to
start the process.
After finishing transmitting the firmware, the system will copy the firmware file and replace
the firmware in the flash. The CLI show …… until the process is finished.
4.2.9
Factory Default
In this section, you can reset all the configurations of the switch to default setting. Click on
Reset the system will then reset all configurations to default setting. The system will show
you popup message window after finishing this command. Default setting will work after
rebooting the switch.