34
openned by text editor to read the file. Administrator can also modify the file, add/remove the
configuration settings, and then restore back to the switch.
Startup Configuration File: After the running-config is saved to flash, the new settings will
be kept and work after power cycle. Administrator can use show startup-config to view it in
CLI. The Backup command can only backup such configuration file to a remote PC or TFTP
server.
To activate the configuration after power reboot,
“Save to Flash” is a Must command.
Please check the description in Ch4.14
Once selecting and configuring the settings are done, click on Backup or Restore to run
Note: It is not allowed to type in space key in the path of folder of backup file.
Type the IP address of TFTP Server IP. Then click on Backup/Restore.
Note: point to the wrong file can cause the entire configuration missed
Technical Tip:
Default Configuration File: The switch provides the default configuration file in the
system. Reset button, or
“Reload” command can be used to reset the system.
Running Configuration File: The switch
’s CLI allows viewing the latest settings
running by the system. The information shown here is the settings you set up but
have
n’t saved to flash. The settings not yet saved to flash will not work after power
recycle. You can
use
show running-config
to view it in CLI.
Summary of Contents for JetNet 6910G-M12 Series
Page 5: ...1 5 4 About Korenix 141...
