42
4.3
Port Configuration
This chapter delivers guidance on the configuration setting of switch ports, including port
state enable/disable, auto-negotiation, speed, duplex, flow control, rate limit control and
port aggregation settings. The port status and aggregation information can be also
achieved.
Following commands are mentioned in this chapter :
4.3.2 Port Control
4.3.3 Port Status
4.3.4 Rate Control
4.3.5 Port Trunking
4.3.6 Command Lines for Port Configuration
4.3.1
Understand the port mapping
Before the port setting, please check the port allocation of JetNet 6910G-M12 before
deployment. The port number is indicated as printing number on the front panel. Follow the
port ID to configure JetNet 6910G-M12.
There are 7 Fast Ethernet ports and 3 Gigabit Ethernet ports. In Web UI, the port number
is available from port 1~10, Port 1~7 represents Fast Ethernet ports, and Port 8~10 are
referred for Gigabit Ethernet ports. In CLI, fa1, fa2
…fa7 represent Fast Ethernet ports and
gi8, gi9
… gi10 represent Gigabit Ethernet ports.
4.3.2
Port Control
Port Control commands allow to enable/disable port state, or configure the port auto-
negotiation, speed, duplex and flow control.
Select the port being configured and make changes to the port.
Summary of Contents for JetNet 6910G-M12 Series
Page 5: ...1 5 4 About Korenix 141...
