48
Storm-control for Port 3
Broadcast packets: Disabled
Destination Lookup Failure packets: Disabled
Multicast packets: Disabled
Storm-control for Port 4
Broadcast packets: Disabled
Destination Lookup Failure packets: Disabled
Multicast packets: Disabled
……….
Port Trunking
LACP
Switch(config)# lacp group 1 fa8-10
Group 1 based on LACP(802.3ad) is enabled!
Note: The interface list is fa1,fa3-5, fa8-10
Note: different speed port can’t be aggregated together.
LACP
–
Port Setting
SWITCH(config-if)# lacp
port-priority LACP priority for physical interfaces
timeout assigns an administrative LACP timeout
SWITCH(config-if)# lacp port-priority
<1-65535> Valid port priority range 1 - 65535 (default is
32768)
SWITCH(config-if)# lacp timeout
long specifies a long timeout value (default)
short specifies a short timeout value
SWITCH(config-if)# lacp timeout short
Set lacp port timeout ok.
Static Trunk
Switch(config)# trunk group
<1-8> Valid group range 1-8
Switch(config)# trunk group 2 fa6-7
Trunk group 2 enable ok!
Switch(config)# trunk group 1 fa11-12
Trunk group 1 enable ok!
Switch(config)# trunk group 2 fa11-12
Can't set trunk group 2 enable!
The group 2 is a static aggregation group.
Display – LACP
Switch# show lacp
counters LACP statistical information
group LACP group
internal LACP internal information
neighbor LACP neighbor information
port-setting LACP setting for physical interfaces
system-id LACP system identification
system-priority LACP system priority
SWITCH# show lacp port-setting
LACP Port Setting :
Port Priority Timeout
----- --------- --------
1 32768 Long
2 32768 Long
3 32768 Long
……….
Switch# show lacp internal
LACP group 1 internal information:
LACP Port Admin Oper Port
Port Priority Key Key State
Summary of Contents for JetNet 6910G-M12 Series
Page 5: ...1 5 4 About Korenix 141...
