58
Following commands are included in this group:
4.5.1 STP Configuration
4.5.2 STP Port Configuration
4.5.3 STP Information
4.5.4 MSTP Configuration
4.5.5 MSTP Port Configuration
4.5.6 MSTP information
4.5.7 Multiple Super Ring
4.5.8 Multiple Super Ring Information
4.5.9 Loop Protection
4.5.10 Command Lines for Network Redundancy
The STP Configuration, STP Port Configuration and STP Information pages are available
while select the STP and RSTP mode.
The MSTP Configuration, MSTP Port Configuration and MSTP Information pages are
available while select the MSTP mode.
The Multiple Super Ring and Multiple Super Ring Information are available while select the
MSR mode.
4.5.1
STP Configuration
This page shows how to modify the STP mode and the
global STP/RSTP Bridge Configuration.
The STP mode includes the STP, RSTP, MSTP and
Disable. Please select the STP mode for your system
first. The default mode is RSTP enabled.
After select the STP or RSTP mode, continue to
configure the global Bridge parameters for STP and
RSTP.
After select the MSTP mode, please go to MSTP
Configuration page.
Figure 4.4.1.1 show the web page which allows to
select the STP mode, configure the global
STP/RSTP/MSTP settings.
RSTP
RSTP is the abbreviation of Rapid Spanning Tree Protocol. If a switch has more than one
path to a destination, it will lead to message loops that can generate broadcast storms and
quickly bog down a network. The spanning tree was created to combat the negative effects
Summary of Contents for JetNet 6910G-M12 Series
Page 5: ...1 5 4 About Korenix 141...
