91
scheme allows users to assign new weight ratio for each class. The 10 is the highest ratio.
The ratio of each class is as below:
Wx
/ W0 + W1 + W2 + W3 + W4 + W5 + W6 + W7 (Total volume of Queue 0-7)
4.8.2
Port-based Queue Mapping
Choose the Queue value of each port, the port then has its default priority. The Queue 3 is
the highest port-based queue, 0 is the lowest queue. The traffic injected to the port follows
the queue level to be forwarded, but the outgoing traffic doesn’t bring the queue level to
next switch. After configuration, press Apply to enable the settings.
4.8.3
CoS-Queue Mapping
This page is to change CoS values to Physical Queue mapping table. JetNet 6910G-M12
switch fabric can support 4 physical queues, to allow Users CoS value to the different
levels of the physical queue. In JetNet 6910G-M12, users can freely assign the mapping
table or follow the
suggestion of the 802.1p
standard.
After configuration, press Apply to
enable the settings.
4.8.4
DSCP-Priority Mapping
This page allows you to modify DSCP
values to Priority mapping table. The
system provides 0~63 DSCP priority
levels. Each DSCP level can be
assigned into 4 different physical
queue, from lowest 0 to highest 3.
After configuration, press Apply to
enable the settings.
Summary of Contents for JetNet 6910G-M12 Series
Page 5: ...1 5 4 About Korenix 141...
