Appendices
1022
I (Illegal–Index)
Illegal file description
Meaning:
The filename that you specified when saving
a file or creating a directory contained invalid
characters. To solve this problem:
• Change the filename you are specifying. Filenames
not permitted by MS-DOS cannot be used as a
filename.
Illegal SMF data
Meaning:
You attempted to load a file that was not a
Standard MIDI File.
Illegal SMF division
Meaning:
You attempted to load a Standard MIDI File
that was timecode-based.
Illegal SMF format
Meaning:
You attempted to load a Standard MIDI File
of a format other than 0 or 1.
Inconvertible file exists
Meaning:
A file that cannot be used with ISO9660
format exists on the media. To solve this problem:
• Media that was formatted or written by a device
other than the OASYS may be impossible for the
OASYS to convert into ISO9660 format. To perform
the conversion, use the packet writing software that
was used to format or write the media.
Index number over limit
Meaning:
When sampling into RAM in Combination,
Program, or Sequencer mode, there are too many
indexes to be simultaneously converted into a
multisample.
• Either convert the samples into a different program
or multisample, or use Sampling mode to delete
some of the indexes before you continue sampling.
M (Master–Multisample)
Master Track can’t be recorded alone
Meaning:
When realtime-recording a single track, you
attempted to begin recording with the master track as
the current track.
• Select a MIDI or Audio Track for recording, instead
of the Master Track.
Master Track is empty
Meaning:
You cannot open Audio Event Edit because
the Master Track is empty. To solve this problem:
• Execute the Sequencer P4– Track Edit page menu
command
Set Song Length
etc. with an
appropriate length to create a master track, and
then open Audio Event Edit.
Measure number over limit
Meaning:
The attempted edit operation would cause
the track length to exceed 999 measures.
• Delete unnecessary measures.
Measure size over limit
Meaning:
When loading a Standard MIDI File, the
number of events in a measure exceeded the maximum
(approximately 65,535 events).
Meaning:
The attempted edit operation would cause
the maximum number of events in a measure
(approximately 65,535) to be exceeded.
To solve either of these problems:
• Use event editing etc. to delete unwanted data.
Medium changed
Meaning:
When executing the
Copy
command in the
Disk mode Utility page, the media was exchanged or
ejected, and it was not possible to copy between
separate media on the same drive.
Medium unavailable
Meaning:
You selected a medium that does not allow
writing.
Medium write protected
Meaning:
The other writing-destination media is
write-protected.
• Turn off write protect on the other media, and
execute the command once again.
Memory full
Meaning:
In Sequencer mode when editing a song,
track or pattern, the total data of all songs has used up
all of the sequence data memory, and further editing is
not possible. To solve this problem:
• Delete other song data etc. to increase the amount
of free memory.
Meaning:
While realtime recording in Sequencer
mode, there is no more free memory to accommodate
the recorded data, so recording has been forcibly
halted. To solve this problem:
Summary of Contents for Electronic Keyboard
