Program P8: Insert Effect 8–1: Routing
125
8–1f: OSC MFX Send
OSC1 Send1 (to MFX1)
[000…127]
Sets the volume (send level) at which the output of
oscillator 1 will be sent to master effect 1. This applies
only when
Bus Select
(8–1c) is set to
L/R
or
Off
.
If
Bus Select
is set to
IFX1
–
IFX12
, the send levels to
master effects 1 and 2 are set by
Send 1
and
Send 2
(8–
5a) after passing through IFX1–12.
OSC1 Send2 (to MFX2)
[000…127]
Sets the volume (send level) at which the output of
oscillator 1 will be sent to master effect 2 (see “OSC1
Send1 (to MFX1)”).
OSC2 Send1 (to MFX1)
[000…127]
OSC2 Send2 (to MFX2)
[000…127]
Sets the volume (send level) at which the output of
OSC2 will be sent to master effects 1 and 2. These
parameters will be valid when
Oscillator Mode
is set
to Double and
Bus Select
is set to L/R or Off.
Note:
You can use the control surface to control Send1
and Send2. These can also be controlled from the mixer
section of the front panel, or from the P0– Control
Surface page of the LCD screen. Here’s the procedure
for editing these settings from the front panel.
1. Press the CONTROL ASSIGN MIXER
TIMBRE/TRACK switch to turn it on (lit).
2. Press the MIXER KNOBS switch to select
CHANNEL STRIP.
3. Use the MIXER SELECT 1–2 switches to select the
oscillator whose send levels you want to adjust.
4. Use FX SEND 1 (knob 7) and FX SEND 2 (knob 8)
to control the send levels.
If
Bus Select
(IFX/Indiv. Out Assign)
is set to
L/R
or
OFF
, this will control
OSC1 Send1 (to MFX1)
and
OSC2 Send2 (to MFX2)
.
If “
Bus Select
(IFX/Indiv. Out Assign) is set to
IFX1–12
, this will control
Send1
and
Send2
(P8–
Insert FX page).
CC#93 controls OSC 1/2’s Send 1 level, and CC#91
controls the Send 2 level. These are controlled on the
global
MIDI Channel
(Global 1–1a). The actual
send level is determined by multiplying these
values with the send levels of each oscillator.
▼
8–1: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0:
Write Program
. For more information, see “Write
• 1:
Exclusive Solo
. For more information, see
• 2:
Copy Insert Effect
. For more information, see
“Copy Insert Effect” on page 149.
• 3:
Swap Insert Effects
. For more information, see
Summary of Contents for Electronic Keyboard
