Program mode
34
▼
3–1–2: Menu Command
• 0:
• 1:
• 2:
• 3:
For more information, please see “Program: Menu
Command” on page 73.
3–1–3: Modulation
This page contains the settings for Oscillator 1’s filter
modulation. Among other things, you can:
• Control the effect of the Filter Envelope on filter cutoff.
• Assign AMS modulation for filter cutoff.
Filter B is available when the
Filter Routing
is set to
Serial
or
Parallel
. Otherwise, the parameters for Filter B will be
grayed out.
3–1–3a: Filter EG
The Filter EG modulates the Filter A and B cutoff
frequencies over time. You can control how strongly the EG
will affect the filters in three different ways:
• Set an initial amount of EG modulation, using the
Intensity to A
and
B
parameters.
• Use velocity to scale the amount of the EG applied to the
filter.
• Use any AMS source to scale the amount of the EG
applied to the filter.
You can use all three of these at once, and the results are
added together to produce the total EG effect.
To set up the EG itself, including attack and release times,
levels, and so on, please see “3–1–5: EG,” on page 37.
Velocity to A
[–99...+99]
This lets you use velocity to scale the amount of the Filter
EG applied to Filter A.
Velocity control of Filter EG
With
positive (+) values
, playing more strongly will
increase the effect of the Filter EG, as shown in example
B
above.
With
negative (–) values
, playing more strongly will
introduce the opposite effect of the Filter EG–like inverting
the polarity of the envelope. You can use this in several
different ways:
3–1
–3a
3–1
–3b
3–1
–3
Menu
B. Velocity to A = +50
C. Velocity to A = –25
D. Velocity to A = –99
In all examples below, Intensity to A = +50
Original
Filter Cutoff
Original
Filter Cutoff
A. Original EG
Summary of Contents for M50-73
