126
Sound Edit operating mode
Filter: Filter EG
Intensity to A
Specifies the depth and direction of the effect that “AMS” will
have on filter A.
For example if “AMS” is Joystick Y+, higher settings of this
parameter will allow greater change to be applied to LFO1 when
you move the Joystick up in the Y axis.
-99…+99
Parameter value.
Intensity to B
Specifies the depth and direction of the effect that “AMS” will
have on filter B (see “Intensity to A”).
LFO 2
Adjusts the depth of the cyclic modulation applied by LFO2 (set
on “LFO: LFO2”) to the cutoff frequency of filters A and B. For
more information on the parameters see “LFO 1” above.
Filter: Filter EG
Here you can make settings for the EG that will produce time-
varying changes in the cutoff frequency of filters A and B for the
selected oscillator. The depth of the effect that these settings will
have on the filter cutoff frequency is determined by the “Veloc-
ity” and “Intensity” parameters.
Diagram
The diagram on top of the page shows the Filter envelope line.
Filter envelope
Level
These are the envelope segment levels. The result will depend on
the filter that was selected in “Filter Type”. For example, with the
Low Pass Resonance filter, positive (+) values of EG Intensity
will cause the tone to be brightened by positive (+) levels, and
darkened by negative (–) levels.
Start
This parameter specifies the change in cutoff frequency at the
time of note-on.
-99…+99
Level value.
Attack
This parameter specifies the change in cutoff frequency after the
attack time has elapsed.
-99…+99
Level value.
Break (Break Point)
This parameter specifies the change in cutoff frequency after the
decay time has elapsed.
-99…+99
Level value.
Sustain
This parameter specifies the change in cutoff frequency that will
be maintained from after the slope time has elapsed until note-
off occurs.
-99…+99
Level value.
Release
This parameter specifies the change in cutoff frequency that will
occur when the release time has elapsed.
-99…+99
Level value.
Time
These parameters specify the time over which the filter change
will occur.
Attack
This parameter specifies the time over which the level will
change from note-on until the attack level is reached.
0…99
Time value.
Decay
This parameter specifies the time over which the level will
change from the attack level to the break point level.
0…99
Time value.
Slope
This parameter specifies the time over which the level will
change after the decay time has elapsed until the sustain level is
reached.
0…99
Time value.
Release
This parameter specifies the time over which the level will
change after note-on occurs until the release level is reached.
0…99
Time value.
Note-on
Note-off
Attack
Time
Start
Level
Decay
Time
Release
Time
Release
Level
Attack Level
The specified
cutoff
frequency
Sustain Level
Time
Break
Point
Level
Slope
Time
Summary of Contents for PA 600 QT
