volca nubass System Firmware Update Instructions
2
3.
Connect the audio output of your playback device to the SYNC IN connector on your volca nubass.
Perform the update
1.
Turn the power on while pressing the FUNC and PLAY buttons.
“UPdt” will appear on the display to indicate that volca nubass is in update mode.
2.
Start the playback of volca_nubass_sys_0104.wav to begin updating.
Make sure the volume of the playback device has been turned up.
STEP LEDs 1-16 will indicate the update progress.
Make sure the update file is played from the beginning.
When using a computer, any other system sounds (e.g. email notification) will cause the update
to fail. Make sure all other applications are shut down and do not operate your computer during
the update.
