11)Press change to store.
F. TARIFF RATE FOR 4-STEP TIERED RATE AND NIGHT TIME RATE: [C6] - JAPAN TOKYO-ELECTRIC
TIER No.
Day Time
TIER1
TIER2
TIER3
Night Time
BASIC
BILLING
from [C4 -> Tier
2]
From 08:00
To 22:00
(It depends on
Night Time)
Yen1,296
From 23:00(Tonight)
To
07:00(Next
Moring)
(You can change all.)
Yen12.29/kwh
THRESHOLD
0 ~ 90kwh
91 ~ 230kwh
230kwh over
RATE
Yen23.93/kwh
Yen31.90/kwh Yen36.84/kwh
1)Press [MENU] key for to change [CHANNEL] -> [SET]
2)Press the [SET] key 3 seconds to see [F] [C1] symbol. Press [MENU] key 5 times to change [C1] –> [C6].
3)Press [SET] key to see [F] blinking. Press [SET] key again to see 1-STEP Tiered rate [Yen23.93] on COST screen.
4)Move cursor to proper position using [MENU] key.
5)Press [UP][DOWN] key to adjust the correct value.
6)Press [MENU] to move next position and adjust the correct value. Change all the correct value continuously.
7)Press [SET] to see 1-THRESHOLD Range [90KWh].
8)Press [MENU] to move next position. And adjust the correct value Change all the value continuously.
9)Press [MENU] key to see [F] [90kWh] blinking. Press [UP] key to change the [Tier 2] and you can see [230 KWh].
10)You can see [Yen31.90] If it is okay, press [UP] key to see [Yen36.84] If it is okay, press [SET] key to see [00000
KWh].
11)Press [SET] to see 1-BILLING [Yen12.39] on COST screen. It is for night time rate.
12)Press [SET] to see 1-BILLING START TIME on TIME screen with blink [23]. You can change form 0 ~ 23 with
up/down key for night time rate.
13)Press [SET] to see 1-BILLING TIME on TIME screen with blink [07]. It is end time for night time rate.
14)Press change to store.
G. VOLTAGE SETTING: [C7]
Your default setting is 100 Volts.
1)Press [MENU] key for to change [CHANNEL] -> [SET]
2)Press the [SET] key 3 seconds to see [F] [C1] symbol. Press [MENU] key 6 times to change [C1] –> [C7].
3)Press [SET] key to see [F] blinking and [0 V]. Press [UP] key continuously until you reach [100V = AUTO V].
4)Press [CHANGE] to store.
*If you are using Channel 2 – 10 with PIT3000, Your CRT3000 Channel (e.g. No.1) will get the Voltage value from
PIT3000 automatically when you set the Voltage as [AUTO].
H. PEAK VALUE SETTING: [C8]
Your default setting is 1500W.