KORTING HK 9414 GMRB, User Manual

10

IMPORTANT NOTICE: 

THE OPERATIONS INDICATED BELOW MUST BE FOLLOWED BY QUALIFIED 

PERSONNEL EXCLUSIVELY, IN CONFORMITY WITH THE REGULATIONS IN 

FORCE. 

THE MANUFACTURING FIRM REFUSES ALL RESPONSIBILITY FOR 

DAMAGES TO PEOPLE, ANIMALS OR THINGS, RESULTING FROM THE 

FAILURE TO COMPLY WITH SUCH PROVISIONS.

INSTRUCTIONS FOR THE INSTALLER

INSTALLATION

The installation must be performed in 

conformity with current regulations

.

Installing the top

The appliance is designed to be embedded into 

heat-resistant pieces of furniture.

The walls of the pieces of furniture must resist a 

temperature of 75°C besides the room one.

The equipment must not be installed near 

inflammable materials, such as curtains, cloths,etc.

Make a hole in the top of the piece of furniture, 

with the dimensions indicated in fig. 3, at a 

distance of at least 50 mm from the appliance 

border to the adjacent walls.

MODEL

L (mm)

D (mm)

900

860

480

Any possible wall unit over the cook-top must be 

placed at a distance of at least 760 mm from the 

top.

It is advisable to isolate the appliance from the 

piece of furniture below with a separator, leaving a 

depression space of at least 10 mm (fig. 4).

If the hob is going to be installed on the top of an 

oven, precautions must be taken to guarantee an 

installation in accordance with current accident 

prevention standards. Pay particular attention to 

the position of the electric cable and gas pipe: they 

must not touch any hot parts of the oven.

Moreover, if the hob is going to be installed on 

the top of a built in oven without forced cooling 

ventilation, proper air vents must be installed to 

guarantee an adequate ventilation, with the lower 

air entering with a cross section of at least 200cm

2

, 

and the higher air exiting with a cross section of at 

least 60 cm

2

.

Fastening the top 

Every cook-top is equipped with a special washer. 

A set of hooks is also supplied for mounting the 

cook-top. 

Depending on the type of mounting surface, the 

suitable type of mounting hook is supplied (hook A 

or hook B).

For the installation proceed as follows:

 -Remove the racks and burners from the top.

 -Turn the appliance upside down and lay the 

washer S along the external border (fig. 5).

 -Introduce and place the cook-top in the hole made  

in the piece of furniture, then block it with the V 

screws of the fastening hooks G (fig.6 / 6A).

Installation room

This appliance is not provided with a device for 

exhausting the products of combustion. 

Regarding room ventilation rules where appliance 

is installed make reference to the legislation, in 

conformity with the local regulations.

The room where the appliance is installed must 

have a minimum volume of 20m³

ATTENTION: 

The electrical connection of the cooking hob 

and the oven must be carried out separately for 

security issues and to allow easy removal of the 

oven from the unit

FOR THE U.K. ONLY

The room containing this hotplate should have an 

air supply in accordance with BS 5440: Part 2: 

1989.

 -All rooms require an openable window, or 

equivalent and some rooms will require a 

permanent vent a well.

 -For room volumes up to 5 m

3

 an air vent of 

100cm

2

 is required.

 -For room volumes between 5 m

3

 and 10 m

3

 an air 

vent of 50 cm

2

 is required.

 -If the room is greater than 5 m

3

 and has a door 

that opens directly to the outside, then no air vent 

is required.