ATTACHING BUCKET
Page 9
1. Prior to attaching the bucket, prepare the adapter for engagement by pulling the adapter handle
back (towards the operator) into it’s cocked position. With the bucket positioned on level ground,
tilt the bucket adapter forward approximately 45º. (Fig 9-1) Slowly drive forward into the bucket,
centering the adapter with the bucket as you go and position the top mount bar of the adapter
just below the hooks on the back side of the bucket. (Fig 9-2) Slowly raise the loader paying
attention that both hooks are engaged. With the top mount bar fully engaged, slowly roll the
bucket back. The bottom mount bar of the adapter will come in contact with the bottom of the
bucket. (Fig 9-3) Continue to slowly roll bucket until the adapter handle comes in contact with its
stop and engages itself with the bucket. (Fig 9-4) If the adapter handle does not come in contact
with its stop, continue lowering the loader.
Fig. 9-1 Fig. 9-2
Fig. 9-3 Fig. 9-4
Summary of Contents for Pro 2585
