Chapter 2 Systems specification
2-15
Number
N a m e
C o n t e n t s
Detailed
SP040
Severe error relay
0:No abnormality
1:Error present
ON when severe error occurs
SP041
Slight abnormal relay
0:No abnormality
1:Error present
ON when a slight error occurs
SP043
Battery error
0:No abnormality
1:Error present
ON when battery failure occurs
SP044
MEM error
0:No abnormality
1:Error present
ON when memory error occurs
Latch, STOP, and RUN are reset after the
error occurs.
SP045
I/O error
0:No abnormality
1:Error present
ON when I/O bus or module error occurs.
Latch after error
SP046
Communication error
0:No abnormality
1:Error present
ON when communication error occurs
SP047
I/O array error
0:No abnormality
1:Error present
ON when the module arrangement differs
from that when the power supply is
turned off.
SP050
External diagnostic instruction
relay
0:Non-execution
1:Execution of external diagnostic
instruction
User-programmed FALT command is
turned on when the user-programmed
command is executed.
SP051
Calculation timeout error
0:Be not a timeout
1:Time-out
ON when the operation command
monitoring timer exceeds the set value.
SP052
Syntax error
0:No error
1:Error present
ON when syntax error occurs due to
syntax check
SP053
Arithmetic error
0:No operation error
1:Calculation error present
ON when calculation processing is
impossible
SP054
Communication
instruction
error
0:No error
1:Communication error
ON at communication error when
communication command is executed
SP055
-
SP057
Contract
SP060
Comparison small flag
≧
0:A B
1:A<B
ON when the data to be compared is
smaller than that to be compared by the
comparison operation.
SP061
Comparison matching flag
0:A≠B
1:A=B
Comparison operation turns on when the
data to be compared is the same as the
comparison object.
SP062
Large comparison flag
≦
0:A B
1:A>B
ON when the data to be compared is
larger than that to be compared by the
comparison operation.
SP063
Zero flag
0:The calculation result is non-zero.
1:The result of the operation is zero.
ON when the calculation result by the
data processing instruction is 0.
SP064
Half boro flag
0:Except Half Borrow
1:Half boro time
ON when there is a digit downward
movement to bit 15 due to subtraction
instruction.
SP065
Boro flag
0:Except Half Borrow
1:Half boro time
ON when the digit is lowered to bit 31
due to subtraction instruction.
SP066
Half-carry flag
0:Other than half-carry
1:Time of half carry
ON when there is an upward movement
of digits from bit 15 due to the addition
instruction.
SP067
Carry flag
0:Except Carry
1:When the calculation result is
carried
ON when there is an upward movement
of digits from bit 31 due to the addition
instruction.
Summary of Contents for Kostac SJ-Ether Series
