LIGHTING AND SHUTDOWN PROCEDURES (continued)
LIGHTING
1. Set thermostat to the lowest setting, if installed.
2. Turn off all electrical power to the appliance. (Fan).
3.
Open lower grill to access the gas valve & controls.
A.
Push gas control knob in slightly and turn
clockwise to “OFF”. Wait five (5) minutes to allow any
gas that may have accumulated inside the firebox to
escape. If you then smell gas,
STOP!
Follow the
safety information on the front cover and on the previ-
ous page of this installation manual. If you don‟t smell
gas, go to the next step.
5 MINUTES
A
NOTE: Gas control knob cannot be turned from “PILOT” to “OFF”
unless knob is pushed in slightly. Do not force
.
B
PILOT
PILOT TUBE
B. Locate pilot - follow metal tube from gas
control. The pilot is located inside the
combustion chamber.
C. Push gas control knob on the gas valve in slightly
and turn counterclockwise to „PILOT‟. Push valve
knob in and hold while repeatedly pressing the
piezo igniter button until the pilot is lit while con-
tinuing to hold in the gas control knob.
D.
Hold gas control knob in for one (1) minute
after pilot is lit. Release the gas control knob. If
the pilot goes out, repeat steps C-D. When the
pilot is lit, proceed to step E.
C
CAUTION: If knob does not pop up when released,
stop and immediately call your service technician or
the gas supplier.
If the pilot will not stay lit after several
tries, turn the gas control knob to OFF and call your
service technician or the gas supplier.
1 MINUTE
D
E
E. Push gas control knob in slightly and turn
counterclockwise to „ON‟. The burner can now
be turned „ON‟ by depressing the ON/OFF
rocker switch located beside the valve, or wall
switch, OR by setting the thermostat or remote
control to the desired setting.
F. Turn on all electric power to the appliance (if
applicable).
NOTE: When the fireplace is initially lit, condensation
will appear on the glass; this is normal in all gas
fireplaces and will disappear after several minutes.
Page 24
