ELECTRICAL INFORMATION
33
10.0 ELECTRICAL INFORMATION
WARNING: Do not use this fireplace if any part has been under
water. Immediately call a qualified service technician to inspect
this appliance and to replace any part of the control system and
any gas control which has been under water.
WARNING - Electrical Grounding Instructions: This appliance
is equipped with a three-prong (grounding) plug for your
protection against shock hazard and should be plugged directly
into a properly grounded three-prong receptacle. Do not cut or
remove the grounding prong from this plug.
10.1 Electrical Specifications
This appliance, when installed, must be electrically grounded in
accordance with local codes, or in the absence of local codes,
with the National Electrical Code, ANSI/NFPA 70, or the Canadian
Electrical Code, CSA C22.1.
10.2 Wiring Requirements
• The IFC System Module requires 120V of electricity and/or
batteries to operate.
• Using the battery back-up will operate the burner only.
• Optional fan and light components will not function on battery
back up power.
Figure 10.1, Wiring Schematics
BA
TTER
Y P
ACK
PIL
O
T
IGNITER
FLAME SENSOR
MAIN ON/OFF SWIT
CH
885 PR
OFLAME
PIL
O
T
BURNER
SWI BUT
TON (RED)
VARIABLE
SPEED F
AN
VARIABLE LIGHT
S
APPLIANCE
GR
OUND S
TAR
MALE
END
