#LXL-22-L
R.1 4 . 2 0 . 2022
11
HUSSONG MFG. CO., INC.
KOZY HEAT FIREPLACES
3.0
FRAMING
3.1
Installation Planning
•
Alcove Installation
allows the gas stove to be located within
a recessed section of a room. Refer to section
3.4, ALCOVE
INSTALLATION
on page 14 for more information.
•
Masonry Application
allows the gas stove to sit inside an
existing masonry fireplace. Refer to section
3.5, MASONRY
APPLICATION
on page 15 for more information.
•
If planning to convert to propane, it is easier to complete the gas
conversion before installing the gas stove. See the # conversion
kit manual for complete conversion instructions. Refer to section
8.3, CONTROL BOARD REMOVAL AND INSTALLATION
on
page 11 for access to the burner and pilot system before and
after installation.
3.1.1
Appliance Placement Considerations
WARNING: Due to high temperatures, the appliance should be located
out of traffic and away from furniture and draperies.
•
This gas stove must be installed on a level surface capable of
supporting the gas stove and venting. Determine your vent
requirements before framing your appliance
•
This appliance may be installed in a bedroom.
•
Please be aware of the large amount of heat this gas stove will
produce when determining a location.
3.1.2
Floor Support and Protection
•
The appliance must be placed directly on a wood or non-
combustible surface (not linoleum or carpet) extending the
entire depth and width of the gas stove.
•
If this appliance is to be installed directly on carpeting, tile,
or other combustible material other than wood flooring, this
appliance shall be installed on a metal or wood panel extending
the full width and depth of the appliance.
•
If the appliance is to be installed above floor level, a solid,
continuous platform must be constructed below the appliance.
SECTION 3
FRAMING
Installation Planning