28
#LXL-22-L
R.1 4 . 2 0 . 2022
HUSSONG MFG. CO., INC.
KOZY HEAT FIREPLACES
7.0
FIREPLACE SETUP
7.1
Safety Barrier Screen and Overlay
Installation
7.1.1
Safety Barrier Screen
1.
Locate the (4) slots located on each side of the gas stove frame.
2.
Align the notched tabs located on the back of the safety barrier
screen/overlay with the slots on the gas stove frame.
3.
Raise the safety barrier screen front slightly into slots and allow
the tabs to lower into position. See
•
To remove safety barrier screen: lift the screen up and
out of slots.
7.1.2
Overlay
1.
If installed, remove the safety barrier screen.
2.
Align the overlay over the safety barrier screen.
3.
Locate the (4) tabs on the rear of the overlay and hand bend tabs
to secure the overlay to the safety screen front.
4.
Locate the (4) slots located on each side of the gas stove frame.
5.
Align the notched tabs located on the back of the safety screen
with the slots on the gas stove frame.
6.
Raise the safety barrier screen with overlay slightly into slots and
allow the tabs to lower into position.
•
To remove safety barrier screen: lift the screen up and
out of slots.
SECTION 7
FIREPLACE SETUP
Safety Barrier Screen and Overlay Installation–Glass Frame Assembly
7.2
Glass Frame Assembly
WARNING: Do not operate this fireplace with the glass removed,
cracked, or broken. Replacement of the glass assembly should be done
by a licensed or qualified service person.
Refer to
FIGURE 7.2
with the following instructions.
7.2.1
Remove Glass Frame Assembly
WARNING: Do not remove the glass assembly when hot.
1.
Remove the safety barrier screen.
2.
Locate (2) spring-loaded latches securing the glass assembly at
the top of the firebox. Use the provided tool to unlatch the latch
assemblies from the flange on top of the glass valance.
3.
Tilt the top of the glass valance forward and lift up to remove the
valance resting on the bottom frame rail.
7.2.2
Install Glass Frame Assembly
1.
Tilt the top of the glass valance forward and align the glass
valance with the bottom frame rail.
2.
Use the provided tool to pull the (2) latch assemblies to latch
with the flange on top of the glass valance.
3.
Reinstall safety barrier screen.
FIGURE 7.1
Safety Barrier Screen Installation
FIGURE 7.
Glass Frame Assembly Removal and Installation
