#LXL-22-L
R.1 4 . 2 0 . 2022
29
HUSSONG MFG. CO., INC.
KOZY HEAT FIREPLACES
FIGURE 7.4
Completed Installation
7.3
#LX22-500 Log Set Installation
CAUTION: Do not place logs directly over burner portholes. Improper
log placement may affect flame appearance and cause excessive soot
to build upon the logs and glass.
•
If converting to propane, complete the conversion before
installing the log set. Follow the conversion instructions included
with the kit.
•
Log numbers are located on each log. Refer to the following
instructions and illustrations for proper log placement.
1.
Set log LX1 on the rear log plate, as shown in
FIGURE 7.3
.
2.
Align the holes in the bottom of log LX2 with the studs on the
left side of the burner and place log LX2 in to position, as shown
in
FIGURE 7.3
.
3.
Align log LX3 with the notch in the ash panel and place into
position, as shown in
FIGURE 7.3
.
SECTION 7
FIREPLACE SETUP
#LX22-500 Log Set Installation–#LX22-500 Log Set Installation
4.
Align the holes in the bottom of log LX4 with the studs on the
right side of the burner and place log LX4 in to position, as
shown in
FIGURE 7.3
.
5.
Align log LX5 with the left pin in log LX1 and the notch in log
LX2 and position as shown in
FIGURE 7.4
.
6.
Align log LX6 with the pin in the middle of log LX1 and the
notch in the middle of the ash panel, and position as shown in
FIGURE 7.4
.
7.
Align log LX7 with the right pin log LX1 and the notch in the
right side of the ash panel, as shown in
FIGURE 7.4
.
8.
Align log LX8 with the notch in the ash panel, as shown in
FIGURE 7.4
.
9.
Use a stiff or steel bristle nylon brush to distribute rockwool
embers onto logs and burner.
FIGURE 7.3
Base Logs
