34
1. Set ON/OFF rocker switch to OFF position.
2. Install 4 AA batteries (included in components packet) into battery backup holder.
3. Connect IFC Control Module to AC power supply.
4. Install 3 AAA batteries (included in components packet) into remote
control battery bay (located on base of remote control).
NOTE
: Performing the next step will initiate Pilot Start-up in Manual Mode:
Pilot igniter will spark repeatedly.
Pilot will ignite if gas is supplied to the fireplace.
Remove all packaging / combustible material from fireplace before
proceeding.
Press
ON/OFF
key on remote control. The display will show all active icons on the screen. A single ‘beep’ from IFC Control
Module will confirm reception of the command.
With the system in
OFF
position, press Thermostat Key and Mode Key at the
same time to change from degrees F to degrees C. Look at the remote
control LCD screen to verify that C or F is visible on right side of Room
Temperature display.
Press
ON/OFF
key on remote control. The display will show only room temperature and icon on the screen. A single ‘beep’
from IFC control module will confirm reception of the command.
The remote control has six (6) flame levels. With system ON and flame level at maximum, press Down Arrow Key once to re-
duce flame height by one step until flame is turned off. The Up Arrow Key will increase flame height on step each time it is
pressed. If Up Arrow Key is pressed while system is on but flame is off, the flame will come on in High position. A single ‘beep’
will confirm reception of the command. When SMART Thermostat is activated, manual flame height adjustment is disabled.
SW1 Button
LEDs
5. Press red SW1 button on IFC control module until module beeps three (3) times and/or an amber LED is illuminated indi-
cating the IFC control module is ready to synchronize with the remote control .
6. Within five (5) seconds push remote control
ON/OFF
button. The IFC control module will beep (4) times to indicate the re-
mote control’s command is accepted and set to the particular code of that remote control. Press remote control
ON/OFF
button again. The pilot will shut down indicating the remote has taken over. The system is now initialized.
7. Setting ON/OFF rocker switch to ON position will allow you to operate fireplace with remote control.
15.0
SYSTEM OPERATION
15.1
Initializing the System for the First Time
15.2
Temperature Display
15.3
Turn ON the Appliance
15.4
Turn OFF the Appliance
15.5
Manually Control Flame with Remote Control
Figure 15.1, IFC Control Module
Figure 15.2, Temperature Locations
Figure 15.3, Flame Levels
