02
08
03
01
The Krabat Sheriff S2 has the following main components:
01
Saddle seat with adjustable angle of the sitting unit, upholstery
02
Adjustable backrest, upholstery
03
Adjustable footrests
04
Frame
05
Propelling wheels
06
Fly wheel
07
Parking brake
08
Antitipper
Main components
02.0
04
07
05
06
Fig. 01
Main components
To obtain the optimal sitting position the height and angles of the seat, backrest
and footrests need to be adjusted. This should be done by a therapist who has
received training from Krabat AS, or a representative for Krabat AS
Most of the angles can be adjusted infinitely, or with the accompanying 4 mm Allen key situated under the seat.
Always tighten all screws after adjusting the wheelchair.
The wheelchair is for indoor and outdoor use on hard and flat surfaces.
If you do descend a hill lean towards the ground, avoid sharp curves and sudden stops. PS: The handbrake is a
parking brake. Do not under any circumstances use this brake when going downhill.
Always activate the brake when going in or out of the wheelchair.
The use of this wheelchair should be discussed with your therapist or someone who knows the child well. It
is important to establish in which situations the child should use the wheelchair, how long they should use it
and when to progress the time spell. This needs to be evaluated continuously as the child gets familiar with
the wheelchair.
It is important to get information about how to get in and out of the wheelchair. This should be done under the
individual trial or at delivery. Make sure the parking brake is activated before placing a child in the wheelchair.
Use
03.0
Place the feet on the footrest and tighten the belts. Children who use ankle-foot orthotics should wear these together
with their shoes, whilst sitting in the Krabat Sheriff S2.
The height of the footrests is done by adjusting the strap between the frame and the footrests. In order to do so
loosen the 4 screws which adjust the position forward or backward along the frame (fig. 02a). Each footrest is
mounted with 2 screws. We can adjust the width and angel of the footrest by loosening the front screw (fig. 02b).
By loosening both screws, we can adjust the rotation of the footrest (fig. 02b).
It is important to tighten the screws properly after adjustment.
Footrests
03.1
Fig. 02a
The height of the footrest is adjusted by loosening
4 screws.
Fig. 02b
The width and angel is adjusted by loosening the front
screw on top of the footrest.
Krabat
Sheriff
7
6
Krabat
Sheriff
