25
ГАЗОВАЯ ПЛИТА
GAS STOVE
ИНСТРУКЦИЯ ПО ЭКСПЛУАТАЦИИ • USER GUIDE
To ignite the oven, you need to press and hold the corresponding knob for 5 –10 seconds.
Then press the electric ignition button. After igniting the burner, you must additionally hold the
handle for 10 –15 seconds. Then the handle can be released, and the burner will continue to
burn independently. If the burner does not ignite, repeat the previous steps. After the burner is
lit, the oven door can be closed in 2 minutes. You can turn the light bulb on and off using the
light switch for internal oven lighting (the control panel may differ depending on the model).
INSTALLATION
attention! The appliance must be installed by a qualified installer who is familiar with
the current installation rules.
• This product should be installed and used in strict accordance with the instructions in this
manual and with applicable state and local standards and regulations.
• The room must be well ventilated, with ventilation installed, make sure that it is well ventilated.
Consult your qualified installer if you are not sure what kind of ventilation you will need.
• Vents must have a cross-section of at least 100 cm and must be protected from accidental
blocking (protection with metal bars or nets). Make sure that there is no other furniture
behind the back of the stove.
• The air flow between the adjacent room and the room where the appliance is installed must
be free through permanent openings (which can be obtained by increasing the gap between
the door and the floor).
• The stove must be installed steadily on a flat surface away from heating appliances and
materials. A note about the installation of the plate must be made in the "Installation Card".
• All furniture adjacent to the gas stove must withstand a temperature of at least 85°C above
the average room temperature. The distance to the adjacent walls and kitchen furniture
should be at least 2 cm. The height from the gas stove to the hood must be at least 65 cm.
• It is not recommended to install the appliance near refrigerators or freezers, in order to
reduce their performance.
• The buyer is responsible for installing the appliance. Assistance provided by the manufacturer
due to incorrect installation is not included in the warranty.
ADJUSTMENT OF THE PLATE LEGS
The adjustable legs ensure a balanced and stable position of the board on the base. With
the feet you can also adjust the height of the board.
GAS CONNECTION
The appliance must be connected to a gas source or cylinder in accordance with the
specifications of current standards and configured for the appropriate type of available gas.
The appliance is configured to work with natural gas. If the type of gas available does not match
the type for which the appliance is installed, replace the appropriate burner jets (included) with
a suitable one for the gas used by contacting the nearest specialist company.
Only a qualified specialist should install and connect the stove to the gas source,
as well as replace the burnes jets!
For safe installation and operation, make sure that the gas supply pressure corresponds
to the values given in the «Table of injectors and gas flow». If the appliance is supplied with
