OPERATION INSTRUCTIONS
SANDPAPER PUNCH
To remove dust effectively from the work surface, the 1/4 sheet of sandpaper must have
holes punched through the surface. A sandpaper punch is included with your
sander. After attaching the sandpaper to the palm sander, align the sandpaper with the
punch, and push down on the sandpaper until the punch has pierced the sandpaper. The
sandpaper is now ready to use with the dust collection system on your sander. See FIG. 5.
ROCKER “ON/OFF” SWITCH
To turn the tool “ON” or “OFF”, push in the switch rocker to the left or right side of the tool.
Be sure sander is “ON” and at full speed before beginning sanding operation. Remove the
tool from the work surface before turning “OFF”.
SANDING
Do not place excessive pressure on the sander. Excessive pressure on the sander may
result in an uneven sanding job and can also cause overheating and possible damage to the
motor.
Do not leave the tool sanding in one spot for an extended time, otherwise uneven sanding
will result.
TM
FIG. 5
KRAFTtech
PS160CA-3
Page 9
