• 9 •
lithium battery. If you hear only a click and the engine does not turn
over, try the following:
With the jump starter connected to the car battery and the green LED
illuminated on the smart cable, turn on all lights and electrical accessories for
one minute. This draws current from the jump starter and warms the battery.
Now try to crank the engine. If it does not turn over, repeat the procedure.
Extremely cold weather may require two or three battery warmings before
the engine will start.
IMPORTANT:
DO NOT attempt to jump start your vehicle more
than three consecutive times. If the vehicle will not start after three
attempts, consult a service technician.
8. After the engine starts, unplug the battery clamps from the jump starter
socket and then disconnect the black clamp (-) and the red clamp (+),
in that order. Slide the ON/OFF switch to the OFF position.
9.
Recharge the unit as soon as possible after each use.
7.2 CHARGING A MOBILE DEVICE, USING THE USB PORTS
The 506.000.100 includes three USB ports. The standard one
provides up to 2.4A at 5V DC.
The second port is a 3A type C
input/output USB up to 15W.
The third port is a Quick Charge 3.0™,
which provides up to 5V at 3A, 9V at 2A or 12V at 1.5A.
1.
Consult your mobile device manufacturer for proper charging power
specifications. Connect a mobile device cable to the appropriate USB port.
2.
Slide the ON/OFF switch to the ON position. Charging should begin
automatically. The display will show which port is in use.
3. Charging time will vary, based on the mobile device’s battery size and the
charging port used.
NOTE: Most devices will charge with any of the USB ports, but may
charge at a slower rate.
NOTE:
The 3A
type C USB port requires a specific charging cable
(not included).
4. When finished using the USB port, disconnect the charging cable from
your mobile device and then disconnect the charging cable from the unit.
Slide the ON/OFF switch to the OFF position.
5.
Recharge the unit as soon as possible after each use.
NOTE: If no USB device is connected, power to the USB ports will
automatically shut off after 30 seconds.
7.3 USING THE LED LIGHT
1.
Slide the ON/OFF switch to the ON position.
2.
Hold down the display button for 3 seconds.
3. Once the LED light is on, press and release the display
button to cycle
through the following modes:
•
Steady glow
•
Flash for an SOS signal
•
Flash in strobe mode
4. When finished using the LED light, press and hold the display
button
until the light turns off.
5.
Slide the ON/OFF switch to the OFF position.
EN
