908 - Connecting the 908
7
4
Connecting the 908
Always switch off the power to each device before connecting it to your
908
. After connecting your
908
, connect its power and then switch on
the power to each device.
To connect the
908
, as illustrated in the example in
Figure 2
, (see the input/output
connections in
Section
4.1
) do the following:
1. Connect an unbalanced stereo audio source (for example, the unbalanced
stereo audio output of a DVD player) to the L and R INPUT 1 RCA
connectors.
2. Connect a balanced stereo audio source (for example, the balanced stereo
audio output of a DVD player) to the INPUT 2 terminal block connector.
3. Connect the OUTPUT terminal block to a pair of loudspeakers:
Connect the “L+” and the “L-” terminal block connectors to the left
loudspeaker, and the “R+” and the “R-” terminal block connectors to the right
loudspeaker.
Do not ground the loudspeakers.
4. Connect the 24V DC power adapter to the power socket and connect the
adapter to the mains electricity (not shown in
Figure 2
).
5. If required, connect:
The 10V CONTROL terminal block connector to an external controller
(for example, the Kramer
RC-63A
)
(see
Section
4.2
)
The RS-232 port to a PC and/or serial controller (see
Section
4.3
)
The Ethernet port to a PC or a network hub or router (see
Section
4.4
)
i
Summary of Contents for 908
Page 2: ......
