KRAMER: SIMPLE CREATIVE TECHNOLOGY
Setup and Installation
6
4.4 Configuration Settings
The
Cobra R500A
and the
Cobra R500-2
are configurable for various video,
audio and serial modes. Note that a compatible transmitter unit must be used
at the source end. Reference the appropriate transmitter user guide or call for
technical assistance. It is not possible to change an audio unit to a serial unit
and vice versa. A dipswitch on the receiver unit is used to set the video,
audio, serial configuration mode. Table 3-1 below shows the configuration
settings (ON = down, OFF = up):
NOTE: There are no user serviceable parts inside the Cobra R500A / Cobra
R500-2. All adjustments are performed externally.
Table 1: Cobra R500A / Cobra R500-2 Configuration Settings
SW Configuration Settings
SW position
1
2
3
Signal
Setting
L/R Audio
On (100 term.)
ON
ON
R500A models
On (no term.)
OFF
ON
Off
OFF OFF
Serial
Duplex
OFF OFF
R500-2 models
Simplex
ON
OFF
Video
RGBHV
ON
All Models
Composite
OFF
S-Video
OFF
Component
OFF
4.5 Video Adjustment
The only adjustments required on the
Cobra R500A
and
Cobra R500-2
are the
SW positions 4 and 5 which must be set to compensate for cable length.
Using the table below as a guide, turn SW positions ON or OFF for best
picture clarity (ON = down, OFF = up):
Table 2: Cable Length EQ Settings
Cable distance EQ settings
Cable Length
4
5
(0-125 Ft)
OFF
OFF
(125-250 Ft)
ON
OFF
(250-375 Ft)
OFF
ON
(375-500 Ft)
ON
ON
Summary of Contents for Cobra R500-2
Page 13: ...11...
