![background image](http://html.mh-extra.com/html/kramer/fc-10/fc-10_user-manual_2001525024.webp)
Kramer Electronics Ltd.
22
Figure
14
:
FC-10 and FC-10D Fuse Location
12.2
Video Signal
Problem Remedy
No video at the output
device
1.
Confirm that your source and output devices are powered on and connected
properly. The input of your machine should be of an identical signal format
at the output of your source. Signals at the output of your machine should be
of an identical signal format as at the input of your display.
2.
Confirm that any other device in the signal path has the proper input and/or
output selected.
3.
Use a Video Tester to help trace faulty cables and equipment (see section 4.1
"Optional Accessories")
Video level is too high or
too dim.
1.
Verify that the lines are well matched through 75ohm impedances; otherwise
it results in a video level that is too high or too dim.
2.
Confirm that the connecting cables are of high quality and properly inserted.
3.
Check level controls located on your source input device or output display.