Initial Configuration and Use Overview
13
5.1
Configuring the FC-21ETH, FC-22ETH and FC-24ETH
To configure the FC-21ETH
,
FC-22ETH
and
FC-24ETH
:
1. Connect the Ethernet port on the rear panel of the
FC-21ETH
,
FC-22ETH
and
FC-24ETH
to a PC either directly or via a LAN, (see
).
2. Using a Web browser, (see
Section
Section
) browse to the
General Info home page (see
).
3. Click on Device Settings to browse to the Device Settings page, (see
4. Enter the time and date manually, or enter the Time server address for
automatic time and date synchronization.
5. Click Save Changes.
6. Click on Communication to browse to the Communication page, (see
7. Enter the IP address, mask and gateway for static IP addressing and Click
Set.
—Or—
Click DHCP On for dynamic IP addressing.
Note
: If you have changed the IP from the default setting, you must reload
the General Info home page again using the new IP address.
8. Click on Serial Ports Settings to browse to the Serial Port Settings page,
(see
9. Associate the required serial ports with their corresponding TCP/UDP
settings.
10. For each associated serial port, enter the serial port configuration
parameters using the drop-down lists under Serial Configuration.
11. Click Save Changes.
Summary of Contents for FC-21ETH
Page 2: ......
Page 28: ...24 Remote Operation via the Web Pages Figure 14 General Info Page...
Page 59: ......
