8
FC-42 - Connecting the FC-42
5
Connecting the FC-42
Always switch off the power to each device before connecting it to your
FC-42
. After connecting your
FC-42
, connect its power and then switch
on the power to each device.
To connect the
FC-42
, as illustrated in the example in
Figure 3
, do the following:
1. Connect a component video source (for example, an HDTV Satellite receiver
source) to the Y, P
B
,
P
R
INPUT BNC connectors.
2. Connect the OUTPUTS:
Connect the SDI BNC connector to an HD-SDI acceptor (for example,
a non-linear editor)
Connect the SDI BNC connector to an HD-SDI acceptor (for example,
an HD-SDI display)
Connect the RGB/HV 15-pin HD computer graphics video connector to
an RGBHV acceptor (for example, a projector)
3. Connect a PC or other controller, if required (see
Section
5.1
).
4. Connect the power cord (not shown in
Figure 3
).
i
Summary of Contents for FC-42
Page 2: ......
Page 12: ...FC 42 Connecting the FC 42 9 Figure 3 Connecting the FC 42 Component to HD SDI Converter ...
Page 20: ......
