Kramer Electronics Ltd.
KIT-400
– Using Embedded Webpages
31
Viewing the Audio Input Source
The audio input source is defined via DIP-switches 3 and 4 on the
KIT-400T
). You can view the input audio source in the Switching
page.
1. In the Navigation pane, click
Switching
. The Switching page appears (
2. View the input audio source according to DIP-switch setup.
The input audio source is viewed.
Adjusting the Audio Output Volume
KIT-400T
enables adjusting the audio output volume via the embedded webpages.
To adjust the audio output volume:
1. In the Navigation pane, click
Switching
. The Switching page appears (
2. Do any of the following:
▪
Enter the audio volume value.
▪
Use the slider to set the volume.
▪
Click to mute the audio
Audio output volume is adjusted.
Controlling Receiver Parameters
Using the
KIT-400T
Switching webpage, you can control
KIT-400R
’s relay, and you can put
KIT-400R
into standby mode or wake it from standby mode.
To control KIT-400R parameters:
1. In the Navigation pane, click
Switching
. The Switching page appears (
2. Do the following:
▪
Click
ON
or
OFF
to energize or release the relay.
▪
Click
ON
/
OFF
to put the device in standby mode or wake it from standby mode.
KIT-400R
parameters are set.
Defining General settings
KIT-400T
enables performing the following actions:
•
Changing the device name (click
Set
to save the name).
•
Defining Remote Buttons Functionality
•
•
