Step 3: Mount KT-1010 / KT-1010RB
This section describes
KT-1010
but applies also to
KT-1010RB
.
To mount KT-1010 on a wall using the VESA kit:
1. Secure the on-wall mount to the wall using the installation
screws.
2. Attach the panel mount bracket to the VESA mounting holes on
the rear side of the
KT-1010
.
3. Slide the panel mount bracket to the on-wall bracket already
mounted on the wall.
To mount KT-1010 on a table:
1. Remove the two panel screws on the rear lower-side
panel of the tabletop mount.
2. Pass the cables through the opening on the rear side.
3. Connect the cables to
KT-1010
.
4. Turn the power switch on the rear of the touch panel
(14) to ON.
5. Place
KT-1010
into the tabletop mount.
6. Reconnect the lower-side panel using the two panel
screws.
7. Secure
KT-1010
from the rear side, via the Tabletop
Mount holes, to the VESA mounting holes on the rear
side of the
KT-1010
.
If required, lock the device using the Kensington lock
slot on the right lower side of the table-mount top.
•
Ensure that the environment (e.g., maximum ambient temperature & air flow) is compatible for the device.
•
Avoid uneven mechanical loading.
•
Appropriate consideration of equipment nameplate ratings should be used for avoiding overloading of the circuits.
•
Reliable earthing of rack-mounted equipment should be maintained.
•
Maximum mounting height for the device is 2 meters.
Step 4: Connect power
Connect the Ethernet port to a PoE Ethernet port, using a PoE-compliant Ethernet cable.
Alternatively, or in addition to PoE powering, connect the power adapter to the 12V AC/DC power socket and to the mains
electricity.
Safety Instructions (See
for updated safety information).
Caution:
•
There are no operator serviceable parts inside the unit.
Warning:
•
Use only the power cord that is supplied with the unit.
•
Disconnect the power and unplug the unit from the wall before installing.
Step 5: Operate KT-1010 / KT-1010RB
1. Turn the power switch on the rear of the touch panel to ON.
Wait for Kramer Control log-in page to load.
2. Sign in as follows:
▪
If the device is connected to the Internet via cable, click
SIGN
IN
on
the panel.
▪
If the device is connected to the Internet via Wi-Fi:
Press the Exit button (on the
KT-1010/KT-1010RB
top side) and
then type the password (default: Kramer).
Click
Home Page
>
Settings
>
Wi-Fi
and choose your SSID Network.
Reboot your device.
KramerAppUpdate automatically updates Kramer apps.
Tap
Home-Page>App Icon>KramerAppUpdate
to view installed and
available app versions and to change the Server Check Interval.
3. Operate the Kramer Control App.