14
TBUS-1Axl - Installing the TBUS-1Axl
2. Place the
T-RC8IR
over the
RC-8IR
enclosure so that both face plate holes
are aligned with the face plate holes on the
RC-8IR
enclosure and the IR IN
receiver fits into the IR IN opening.
3. Insert the faceplate screws through the
T-RC8IR
and
RC-8IR
enclosure
faceplate holes, and tighten.
Installation Instructions
To install the
T-RC8IR
:
1. Insert the
T-RC8IR
assembly through the dual power socket opening from
beneath.
2. Use the two power socket screws to tighten the
T-RC8IR
assembly in
place.
5.1.6
Installing the SI-1VGA / RC-3TB
To install the
SI-1VGA
/
RC-3TB
module, place it under the designated opening in
the
T1AF-14L
(P/N: 80-000699) and then screw and tighten it in place using two
screws supplied with the inner frame.
5.2
Installing the Inner Frame
To install the inner frame:
1. Place the inner frame inside the
TBUS-1Axl
enclosure.
2. Set the required height using your fingers to bring the inner frame to the
desired position, screw and tighten it in place using the height adjustment
screws (supplied with the inner frame).
i
Inner frame kits come with assembly instructions.
